Skip to content
English
Go to eino.ai
  • There are no suggestions because the search field is empty.

📱 How to Configure Client Settings

Set client parameters such as height, transmission power, and MIMO capabilities to accurately simulate uplink and downlink performance.

 

⚙️ Step 1: Open the Client Configuration Menu

  • The Client Configuration menu is located in the top header.

  • Click to open it.

📏 Step 2: Set Client Height

  • Example values:

    • Phone → 1.5 m

    • Camera → 10 ft

  • You can also set a rule: Automatically place clients 5 ft above each roof.

📡 Step 3: Configure Transmission Power

  • Set the Tx power of the client device.

    • Example: iPhone → up to 20 dBm (typically ~15 dBm).

  • For CPE devices, specify antenna gain.

🔗 Step 4: Define Device Capabilities

  • Set supported modulation and MIMO options:

    • Downlink → 256-QAM, 4x4 MIMO

    • Uplink → 64-QAM, 2x2 MIMO

✅ Step 5: Apply Settings

  • Click Apply to confirm.

  • All calculations and simulations will update automatically.

🌡️ Step 6: Analyze Heat Maps and KPIs

  • Heat maps and KPIs update based on client configuration:

    • Downlink → influenced by modulation & MIMO.

    • Uplink → strongly affected by transmission power.

  • You can view separately:

    • Uplink & Downlink heat maps

    • KPIs: SINR, RSSI, throughput, primary/secondary metrics.

💡 Tip: Keep in mind that uplink results are more sensitive to client-side transmission power, while downlink is often influenced by infrastructure capabilities.